Hi there everyone, I am currently trying to geometry optimize a stack of Au (111) 2x2 surfaces, specifically by fixing the bottom 3 surfaces and relaxing the top 3.<div><br></div><div>Unfortunately, the top surfaces completely mess up and the final structure looks bad. When I turn KPOINTS on  (3x3x1 or 5x5x1), it no longer happens.</div><div>Finally, when I lower the cutoff to 300, but I leave KPOINTS off, I get a good optimized geometry, but when I try to perform a CO adsorption with that optimized structure, it severely deforms as well.</div><div><br></div><div>Does anyone have a solution to my problem, particularly one that doesn't change the ELECTRONIC_TEMPERATURE, KPOINTS or CUTOFF. Is it the need for KPOINTS in a small structure like this that messes up the results?<br><br>I have attached all my relevant files.<br><br>Kind regards,<br>Lenard</div>