<div>Hello everyone,</div><div><br></div><div>I generated CUBE file using the V_HARTREE_CUBE command. However, now I am trying to plot the plane average electrostatic potential along Z-axis. Based on suggestions from other conversations here I installed Cubecruncher but couldn't figure out the proper syntax to use it </div><div><br></div><div>./cubecruncher.x -espot -i input.cube -o output.cube </div><div><br></div><div>can someone please correct the syntax.</div><div><br></div><div>Since I couldn't figure out the correct syntax for cubecruncher I used cubetoolz script from : <a href="https://github.com/funkymunkycool/Cube-Toolz">https://github.com/funkymunkycool/Cube-Toolz</a> and generated the plane average electrostatic potential file along Z-axis and plot the output.</div><div><br></div><div>To verify if the plot I generated is correct, I repeated the experiment using VASP and generated the same plot (both attached below). If you look at the Y-axis of both plots you can see that the difference in the scale, VASP is in eV and cp2K in Hartree(?)  </div><div><br></div><div>Does anyone know why there is sure a huge difference in both? difference between two plateaus in VASP is ~3eV and in cp2k is ~50 Hartree. Since both codes generate very similar plots I suspect the problem is with units.</div><div><br></div><div>I have a feeling I am missing something trivial but couldn't figure out what, any suggestions would be of immense help.</div><div><br></div><div>Please and Thank you,</div><div><br></div><div>Harsha.</div>