<div dir="ltr">Hello,<div><br></div><div>I'm running an NPT DFT based MD on an Al64 block at 1000K. I've set up my initial crystal to have the right density (2.735 g/cm3) based on the density of molten Al at 1000K. As my MD progresses, I'd like to make sure that the density is remaining the same or near enough. Is there a print command that would give me the density of my molten block per MD step? I'd like to plot density vs time. </div><div><br></div><div>Thanks!</div><div>Dev</div></div>