<div dir="ltr">Hello,<div><br></div><div>Hope everyone is safe and healthy during this time. I have an geometrically optimized system (DFT, PBE functional, DZVP basis set) that consists of 110 atoms. While performing a vibrational frequency calculation on this system, I am obtaining one or two imaginary modes (< 40 cm-1). I believe by increasing the force convergence criteria during geometry optimization I might be able to get better results. However, even with a force criteria of 0.002 ev/A I am not able to overcome this issue of imaginary modes. My objective is to obtain vibrational modes that are all positive (which I believe corresponds to a minimum).</div><div><br></div><div>I have also tried a longer method where I visualize these particular imaginary modes, slightly change the geometry around the atoms that contribute to this imaginary mode, reoptimize the resulting system and then conduct a vibrational analysis on the newly optimized system. This also has not worked.</div><div><br></div><div>I am attaching my input and frequency files. Any input is greatly appreciated. </div><div><br></div><div>Thank you for your time and patience. </div><div><br></div><div>Sincerely,</div><div>Anantha Nagarajan</div></div>