<div dir="ltr">Dear all,<br>I am studying a binding of water in aluminosilicate systems using RPA. However, available basis set (cc-QZ for H and O and cc-TZ) gives too big BSSE - it is between 15-20 kJ/mol. BSSE on PBE level is small (< 5 kJ/mol) so I assume it is due to auxiliary basis. Therefore, I would like to re-optimize RI basis sets for Al and Si atoms. I had look on regtests: cp2k-3.0/tests/QS/regtest-ri-mp2/opt_basis_O_auto_gen.inp.  and  opt_basis_O_num_func.inp and they run smoothly. I looked also on the tutorial given in https://www.cp2k.org/_media/events:2015_cecam_tutorial:wilhelm_posthf.pdf<br>However, I am still not sure how to continue with my system. I have several questions:<br>1) Because I will run RPA, shall I turn on  the PBE functional in XC section for basis set optimization?<br>2) If I optimize basis set for a simple system such as Al atom to which extend are the parameters reliable/transferable? <br><div>3) Alternatively I looked on BASIS_def2_QZVP_RI_ALL. Is it possible to combine all electron basis with pseudopotentials?  I run the calculations in combination with GTH potentials and I see that the results are very different than when I use cc-QZ basis (adsorption energy of water differs about 20-30 kJ/mol), so I do not trust them much.</div><div><br> </div>Thank you for your help!<br>Kind regards,<br>Katarina<br></div>