<div dir="ltr"><div>Dear All,</div><div><br></div><div>If I get following information in my output:</div><div><br></div><div> SPLINE_INFO| Spline range [bohr]:                          9.000000E-01 2.267671E+01<br> SPLINE_INFO| Spline range used to achieve accuracy [bohr]: 1.162370E+00 2.267671E+01</div><div><br></div><div>does it mean that my LJ potential was modified for atomic distance from 0.9 Bohr to 22.6767 Bohr? <br></div><div>At 22.6767 is my chosen cut-off. If so, how can I know whether this modification isn't too harsh? I mean</div><div>I modify the potential virtually for every distance between atoms until the cut-off distance is reached, <br></div><div>so shouldn't I worry about the minimum being too shallow now for instance?</div><div><br></div><div>On the other hand, the output also says</div><div> SPLINE_INFO| Number of spline points:                      24<br> SPLINE_INFO| Requested accuracy [Hartree]:                 1.000000E-07<br> SPLINE_INFO| Achieved accuracy [Hartree]:                  9.773635E-08<br></div><div><br></div><div>or something similar depending on atoms pair. What does this accuracy actually mean?</div><div><br></div><div>Best wishes,</div><div>Dawid<br></div><div><br></div></div>