<div dir="ltr">Dear cp2k users,<div><br></div><div>I have done a NVT simulation with the temperature set to 673 K</div><div>The idea was to keep the temperature around this value by the use of the CSVR thermostat.</div><div>However, the temperature quickly decreases to around 350 K as shown in the attached figure.</div><div><br></div><div>The MD section of the input file is as follows:</div><div><br></div><div><br></div><div><div>  &MD</div><div>    ENSEMBLE NVT</div><div>    TEMPERATURE [K] 673</div><div>    TIMESTEP [fs] 0.30</div><div>    &THERMOSTAT</div><div>      &CSVR</div><div>        TIMECON [fs] 10</div><div>      &END CSVR</div><div>    &END THERMOSTAT</div><div>    STEPS 100000</div><div>    &PRINT</div><div>      &PROGRAM_RUN_INFO</div><div>        &EACH</div><div>          MD 20</div><div>        &END EACH</div><div>      &END PROGRAM_RUN_INFO</div><div>    &END PRINT</div><div>  &END MD</div></div><div><br></div><div>Why is the temperature decreasing?</div><div>Shouldn't the thermostat be able to bring the temperature up again to the initial value?</div><div>Is there something I do incorrectly in the set-up of this simulation?</div><div><br></div><div>Thanks a lot for your help. </div><div><br></div><div>Regards,</div><div>Torstein</div><div><br></div><div><br></div><div><br></div></div>