<div dir="ltr">Hi everyone,<div><br></div><div>I've recently started to get the following error while running single point energy calculations on some systems. </div><div><br></div><div><div><font face="courier new, monospace"> SCF WAVEFUNCTION OPTIMIZATION</font></div><div><font face="courier new, monospace"><br></font></div><div><font face="courier new, monospace">  Step     Update method      Time    Convergence         Total energy    Change</font></div><div><font face="courier new, monospace">  ------------------------------------------------------------------------------</font></div><div><font face="courier new, monospace">     1 NoMix/Diag. 0.10E+00    3.8     0.75631948      -243.4503623748 -2.43E+02</font></div><div><font face="courier new, monospace">     2 Broy./Diag. 0.10E+00    4.7     0.36183064      -245.7284413793 -2.28E+00</font></div></div><div><br></div><div><div><font face="courier new, monospace"> *******************************************************************************</font></div><div><font face="courier new, monospace"> *   ___                                                                       *</font></div><div><font face="courier new, monospace"> *  /   \                                                                      *</font></div><div><font face="courier new, monospace"> * [ABORT]                                                                     *</font></div><div><font face="courier new, monospace"> *  \___/    Bad condition number R_COND = 0.000E+00 (smaller than the machine *</font></div><div><font face="courier new, monospace"> *    |                             working precision)                         *</font></div><div><font face="courier new, monospace"> *  O/|                                                                        *</font></div><div><font face="courier new, monospace"> * /| |                                                                        *</font></div><div><font face="courier new, monospace"> * / \                                                    common/mathlib.F:710 *</font></div><div><font face="courier new, monospace"> *******************************************************************************</font></div></div><div><br></div><div>Unfortunately, I do not seem to get this error in any consistent fashion, and I have yet to find a common thread as to when/why I get it. Moreover, there are typically two successful SCF calculations before the error is printed, as shown above. These results correspond to the file /NeutralGeo/Cu3(HIB)2-ReorgEnergy-wMetal-eagn-run.out, which I have attached. The general procedure for these calculations is as follows: Submit the "build-submit-reorg-single.bash" file, which creates one directory per charge state (i.e. Anionic/Cationic/NeutralGeo) and fills in the cp2k-reorg-*geo-template.slurm file. This file is submitted to our cluster, along with the template cp2k file, here reorg-BLYP-wD3.inp. The calculations it then runs are a geometry optimization for the corresponding charge state (i.e. GeoOpt for neutral state in NeutralGeo directory), a single point energy calculation using the same charge state and optimized geometry (this was for printing cube files, but I have that turned off now for the sake of figuring out this error), and then two more single point energy calculations for the anionic/cationic state, using the optimized neutral geometry. I had run many fo these before without issue, but after making some small changes to my reorg-BLYP-wD3.inp, this issue appeared. However, commenting out the changes does not seem to solve the issue. I am still working to debug this, but if anybody has some insight, that would be greatly appreciated. Thanks!</div><div><br></div><div>Best,</div><div>     Brian Day</div><div><br></div></div>