<div dir="ltr">Dear all,<div>I am performing a direct-cell optimization of a graphene nano ribbon: the optimization goes well but I am a bit confused about the meaning of the convergence criterion 'Max. gradient' that is, how explained in the tutorial 'Electronic structure using DFT', <span style="caret-color: rgb(51, 51, 51); color: rgb(51, 51, 51); font-family: Arial, sans-serif; font-size: 14px;">the maximal force (seen over all atoms). </span> This number, from what I understood, is the maximum force that you can find in your system acting on the atoms but if I compare this number to the forces print on the specific output file (where there are the three components of the forces acting on the atoms at a specific step) I did not find any match.</div><div>So, my questions are:</div><div>- what does '<span style="caret-color: rgb(51, 51, 51); color: rgb(51, 51, 51); font-family: Arial, sans-serif; font-size: 14px;">maximal force (seen over all atoms)' means?</span></div><div><span style="caret-color: rgb(51, 51, 51); color: rgb(51, 51, 51); font-family: Arial, sans-serif; font-size: 14px;">- </span><font color="#333333" face="Arial, sans-serif"><span style="font-size: 14px;">If I would like that each component of the forces acting on the atoms are lower than a certain value (for example 10^-5 eV/ang), how can I do? There is a specific flag for this? </span></font></div><div><font color="#333333" face="Arial, sans-serif"><span style="font-size: 14px;">Thank you very much for your attention.</span></font></div></div>