<div dir="ltr"><div>Hello, I notice an issue when I perform an MD run on a large system.</div><div><br></div><div>I have that the first steps are fast but they get slower and slower (from the timing in the .ener file), in the output I notice that the SCF run take more and more steps to converge.</div><div>If I stop my calculation and restart it from the restart input file the times go down again.</div><div><br></div><div>I added an extract from my ener file:</div><div><br></div><div>md calculation starts at step 2036 (restart from an existing WFN file), first step take a little more than the subsequents ones. Until 2332 we see the time increase, then I stop and restart CP2K and times go down again<br></div><div><br></div><div>if I grep "SCF run" from the output you have the results in grep_out, and the whole output in raw_out. in md.inp and step.xyz the necessary files for running the md simulation (minus the WFN file) (If you prefer I can attach the restart file, but it is less readable)<br></div><div><br></div><div>Does anyone see something wrong in my input file or know the issue?</div><div><br></div><div>Cheers</div><div><br></div><div>Daniele<br></div></div>