<div dir="ltr"><div>Dear all, <br></div><div><br></div><div>I have two general questions about optimization of cell parameters in cp2k.</div><div><br></div><div>1) How can the Pulay stress be reduced in an optimization of the cell parameters?  In VASP, the recommendation  is to increase the kinetic cut-off energy by approximately 1.5 times the default kinetic cut-off energy. Are there any similar guidelines for cp2k?</div><div><br></div><div>2) I see that the default value for the external pressure is set to 100 bar. Why is this a reasonable default value? If we are comparing the computationally optimized cell parameters with the experimentally determined cell parameters, should we then change the value of the external pressure to the pressure for which the experiment was carried out?</div><div><br></div><div>Thanks for your help. <br></div><div><br></div><div>Regards,</div><div>Torstein</div><div>  <br></div></div>