<div dir="ltr"><div>Dear CP2K community,</div><div>i am currently trying to setup a meaningful QM/MM setup for a doped sodium silicate glass. I would like to have some heavy metal atom and some of its surrounding silicates and sodium atoms in the QM part, while the rest of the glass shall be in the MM part. I have used a dissociative force field with Buckingham potentials for the sodium silicate glass, to allow proper melting of the glass during initial MD runs and would like to keep this force field. However, this force field relies on the partial charges of the Si, O and Na (2.4, -1.2, 0.6). The partial charges for the QM part, which interact with the MM part, additionaly to the Buckingham potentials, are of course not the same as those required by the force field. The result is, that the repulsive part of the Buckingham potential takes over and pushes all QM atoms away.</div><div>I would like to do assign "dummy charges" to the QM atoms (or its current positions) that are the charges of the corresponding MM atoms, while ignoring the charge distribution from the QM calculation. Otherwise the MM part should polarise the QM part as normal. Is there a way to achieve this?</div><div><br></div><div><br></div><div>Best regards</div><div>Phillip<br></div></div>