<div dir="ltr">Dear All,<br><br>I want to perform vibrational analysis and I have checked few input files out there to find out which keywords are necessary. I have first carried out a structural optimization of my periodic system with "CELL_OPT" then used the relaxed atomic positions and lattice parameters in the input file for vibrational analysis. Unfortunately, I encounter the following error message: <br><br>Trying to access result ([DIPOLE]) which was never stored!<br><br>Which has already been discussed in this forum a couple of times. The solutions that I could found are still not solving my issue, so I guess there is something wrong in my input file that I cannot see. It would be really helpful if your expert eyes could spot any mistakes in my input file (attached). No other files except the input, atom coordinates, potential and basis sets files are present in the folder of calculation when the calculation starts.<br><br>Thank you very much for helping me solving this issue.<br><br>Best,<br>Michel.<br></div>