<div dir="ltr">Dear CP2K developers/users,<div>I am using extended Lagrangian metadynamics and it looks like there is something wrong with how the hills are spanned/written when I try to use Langevin thermostat for the metadynamics.</div><div>The problem is that when Langevin is turned on hills are spanned twice. I have the following lines in my output (without anything between them). It seems like it's adding 2 hills instead of 1:</div><div><br></div><div><div> METADYN| Hills number (17) added.</div><div><br></div><div><br></div><div> METADYN| Hills number (18) added.</div></div><div><br></div><div><br></div><div><br></div><div>In the restart file under the        &SPAWNED_HILLS_POS     directive it prints triples of the positions. Something like this:</div><div><br></div><div><div>       &SPAWNED_HILLS_POS</div><div>             1.3038877512362206E+00</div><div>             1.2265614190873904E+00</div><div>             1.2265614190873904E+00</div><div>             1.2265614190873904E+00</div><div>             1.2604256138213792E+00</div><div>             1.2604256138213792E+00</div><div>             1.2604256138213792E+00</div></div><div><br></div><div> </div><div>None of this happens when I turn off the Langevin and use the default (velocity re-scaling) thermostat. </div><div>This happens across versions and with the QUICKSTEP module.</div><div>So, I'm wondering if this is how it should be. If not, is this just an I/O issue or the dynamics is affected too?</div><div>I have attached all the files for you to check.</div><div><br></div><div>Regards,</div><div>Saleh</div><div><br></div><div><br></div><div><br></div><div><br></div></div>