<div dir="ltr">Dear all,<br><br>I am trying to perform Monte Carlo simulation on cyclic molecules in the gas-phase (intended for conformational analysis). I have attached the corresponding input and the topology, this is a test simulation on cyclopentane. The first energy evaluation is working perfectly fine but when the first MC step is about to be carried out, the calculation stops doing anything. The calculation is not crashing initially, only after a few hours at that stage without any visible progress in the calculation (but overall memory usage is very high) and I don't get an error message that I could work with. I have the same problem on several other molecules, all cyclic. When I use the exact same input on a different acylic molecule, I tested for instance propane, but also others, everything is working perfectly fine and the 1000 MC steps are finished within minutes. I have tried to figure out what the problem could be but haven't a solution yet. Does anyone have an idea what could go wrong here? Thank you in advance for any help.<br><br>Robert<br><br><br></div>