<div dir="ltr">Hi,<div><br></div><div>the geo_opt bug was fixed shortly after the posts above - so a recent executable should work fine (the bug was actually for MOM in combination with the MO_CUBES keyword).</div><div><br></div><div>We don't really have a definite protocol for running the method beyond: Converge ground state; Check orbitals; Run MOM calc with appropriate excitations. You might need to set ALPHA in &MIXING quite small (< 0.1). </div><div><br></div><div>For a well separated S1 state, I'd hope it might work quite OK.</div><div><br></div><div>Matt<br><br>On Tuesday, September 13, 2016 at 9:59:13 PM UTC+1, Jen E. wrote:<blockquote class="gmail_quote" style="margin: 0;margin-left: 0.8ex;border-left: 1px #ccc solid;padding-left: 1ex;"><div dir="ltr">Hi All, <br><br>I am a new user of CP2k and I am trying to use the MOM method to converge the S1 excited state of a molecule. I have a few related questions.. 1.) I was wondering if there is a specific protocol for running a MOM calculation  and 2.) Has there been any resolution in getting the MOM method to work with a geometry optimization? <br><br>Thanks very much! <br><br>Jen <br><br>On Tuesday, April 19, 2016 at 4:58:16 AM UTC-4, Matt W wrote:<blockquote class="gmail_quote" style="margin:0;margin-left:0.8ex;border-left:1px #ccc solid;padding-left:1ex"><div dir="ltr">HI Tassem,<div><br></div><div>it should work, in principle. One think that could cause trouble is if the step size is large during the geometry optimization so the orbitals change too much.</div><div><br></div><div>If you send me some output offline, we can have a look.</div><div><br></div><div>Matt<br><br>On Monday, April 18, 2016 at 4:10:30 PM UTC+1, Al-Moatasem El-Sayed wrote:<blockquote class="gmail_quote" style="margin:0;margin-left:0.8ex;border-left:1px #ccc solid;padding-left:1ex"><div dir="ltr">Hi all,<div><br></div><div>I am trying to run a geometry optimization while using the maximum overlap method to occupy an excited state. When I try to do this, the first SCF cycle successfully occupies the higher state I would like to be occupied. I also manage to occupy the state I would like if I just run a single point calculation. However, when the geometry optimization begins, the electron moves back into the lowest unoccupied orbital. So I was wondering if it is actually possible to use the maximum overlap method with a geometry optimization.</div><div><br></div><div>Thanks,</div><div>Tassem</div></div></blockquote></div></div></blockquote></div></blockquote></div></div>