<div dir="ltr">Hello, <br><br>I ran a CI-NEB calculation on co2 adsorption on a metal from the physisorbed to chemisorbed state. After the NEB calculation completed I ran a VIBRATIONAL ANALYSIS on the structure from the NEB which would represent the transition state (I took the structure with the highest energy). I found 3 imaginary frequencies after the VIBRATIONAL ANALYSIS completed:<br><br> VIB|                        NORMAL MODES - CARTESIAN DISPLACEMENTS<br> VIB|<br> VIB|                         1                    2                    3<br> VIB|Frequency (cm^-1)  -373.959745          -155.894278           -82.219450<br> VIB|Intensities           0.000000             0.000000             0.000000<br> VIB|Red.Masses (a.u.)    15.645084            12.197575            14.794711<br> VIB|Frc consts (a.u.)    -0.000783            -0.000018            -0.000002<br>  ATOM  EL             X     Y     Z        X     Y     Z        X     Y     Z<br>    56  O             0.04  0.11 -0.92    -0.02 -0.02  0.19     0.51  0.21  0.24<br>    57  C             0.08  0.06 -0.28    -0.25  0.09 -0.94     0.50  0.20 -0.10<br>    58  O             0.20  0.04  0.04    -0.04  0.02 -0.09     0.57  0.12 -0.01<br><br><br> VIB|                         4                    5                    6<br> VIB|Frequency (cm^-1)   233.171137           297.756764           384.024573<br> VIB|Intensities           0.000000             0.000000             0.000000<br> VIB|Red.Masses (a.u.)    14.149167            15.693032            15.822496<br> VIB|Frc consts (a.u.)     0.000107             0.000316             0.000881<br>  ATOM  EL             X     Y     Z        X     Y     Z        X     Y     Z<br>    56  O            -0.07  0.27 -0.00    -0.30  0.74  0.08    -0.01 -0.19  0.06<br>    57  C            -0.17  0.65  0.13    -0.16  0.23  0.04    -0.17  0.11 -0.05<br>    58  O            -0.22  0.64 -0.05     0.13 -0.50  0.13     0.14  0.09  0.94<br><br><br>I wanted to know the best way to get rid all but one of these imaginary frequencies? The first thing I'm attempting to do is run a TRANSITION STATE calculation on the structure. <br>From what I read on this board another option would be to change some of the XYZ coordinates by using adding a fraction of the atomic displacements to the coordinates from one of the imaginary modes and then run TRANSITION STATE calculation on the new structure.<br><br>Or should I change the coordinates (using the atomic displacements) and then use the new structure to rerun the NEB and then perform the vibrational analysis again?<br>I've included my CI-NEB, TRANSITION STATE, and VIBRATIONAL ANALYSIS inputs.<br> <br>Any advice on what else I could do to get rid of all but one of the imaginary frequencies (or if I'm taking the right steps already) would be appreciated.<br><br>Thanks,<br><br>Natalie<br></div>