<div dir="ltr"><br><div>Dear people,</div><div><br></div><div>I have three questions about a NEB calculation that I am running (see input and output of first replica attached).</div><div><br></div><div>1) The number of replicas is 5, with the first and last replicas fixed. Since the first replica is fixed (indeed the positions are constant in the trajectory output), why is the wave function optimized after every NEB geometry cycle? In the attached output the number of SCF cycles is more than 1 (often more than 100 actually), even though the geometry has not changed.</div><div><br></div><div>2) The number of processors per replica is 8, and I run on 2 nodes of 8 processors each. I see that on node 2, there is an Silver-BAND6.out (and Silver-BAND2.out and Silver-BAND4.out) containing info of SCF cycles and energies and so forth. What is this 6th output doing, considering that there are only 5 replica's (there are only 5 trajectory outputs)?  I was hoping that cp2k would cycle all 5 replicas over the 2 nodes subsequently; instead it puts replica's 1,3, and 5 on node 1, and 2, 4 and 6(???) on node 2. Is there a smarter way to use 2x8 procs on 5 replica's?  (the system does not really scale to 1x16 procs).</div><div><br></div><div>3) The number of SCF cycles is often more than 100 for all replicas. In "normal" geometry optimization runs the number of SCF cycles is typically 7 to 15 (apart from the first round). Is this poor convergence in BAND normal (due to the "stretched" geometries maybe?).  Does anyone have advice on this?</div><div><br></div><div>many thanks in advance.</div><div>Bernd</div><div><br></div><div><br></div><div><br></div><div><br></div><div><br></div></div>